When I went for the mot last weekend, I had a full (to the top) tank of petrol - it's nearly gone:D
I reckon I've done 120 miles in the last week and only a couple of minor irritants so far. First was n/s exhaust kept leaking - turned out that where I'd made my own exhaust flange and welded pipe to it, it was no longer flat. Fixed that with the linnisher and silicon sealant.
Other thing was a progressively worsening oil leak which I had one of the guys near work look at - who found it straight away - oil pump cover nuts were loose.
So, jobs to do are - replace light switches in living/dining rooms, replace shower unit, do extension plans (well, finish them) and get them submitted, then replace bushes in coilover units as they seem a bit worn; come up with some sort of engine stabiliser or remake engine mounts using same sort of bushes used in the wishbones, get car to someone who can do corner weighting/tracking etc etc; replace inner pivots on lower front wishbones with spherical bearing (which will allow me to increase front track width to match rear. And get it painted!
Errr:D
Later
Wednesday, 11 August 2010
Saturday, 7 August 2010
We're on the road again:)
Left work 10 minutes early yesterday so I could get home and sort the last remaing point from the mot fail; being the "hub component fouling chassis" - in effect, because the side panels now stick out further than they used to, the wheel arches rubbed the body.
Easy fix though - just snip the cable tie holder the steering rack rubber in place, slide back and screw two more jubilee clips to each side. Use two each end, but so each clips tail goes into other clip.
Anyway, got up early and got car to test station for 8.00am and had to leave it there for an hour as there were a couple of cars in front of me (though guv'nor said he'd try and get me in between the two - only a retest on the failed parts). Went home and had tea and toast, then more toast!!
At 8:50 I wandered back to shop and was advised he was doing paperwork. Two more mins I was back in car driving home. Put car on driveway, got V5/ins and new mot and drove (other car) to post office. Quarter hour later I was fitting rfl disc in car, then drove off to work, where I had a chat with the chap who'll be doing a bit of paint!!
Me happy, just need to get car set up properly!
Pics and vid to come!
Easy fix though - just snip the cable tie holder the steering rack rubber in place, slide back and screw two more jubilee clips to each side. Use two each end, but so each clips tail goes into other clip.
Anyway, got up early and got car to test station for 8.00am and had to leave it there for an hour as there were a couple of cars in front of me (though guv'nor said he'd try and get me in between the two - only a retest on the failed parts). Went home and had tea and toast, then more toast!!
At 8:50 I wandered back to shop and was advised he was doing paperwork. Two more mins I was back in car driving home. Put car on driveway, got V5/ins and new mot and drove (other car) to post office. Quarter hour later I was fitting rfl disc in car, then drove off to work, where I had a chat with the chap who'll be doing a bit of paint!!
Me happy, just need to get car set up properly!
Pics and vid to come!
Wednesday, 4 August 2010
Nearly there
G'day.
Since the last post, we've had a weekend away in the caravan which was good fun, but prevented me from finishing the car; which was just tough.
I've been doing bits and pieces to the car since the MOT failure and have done all the required jobs except the steering restriction - which shouldn't take long - hope to do that on Friday eve - maybe get a retest on Saturday.
Did the new exhausts over the last couple of evenings and (nearly) finished attaching them tonight (only a bit of steel to connect rear of exhaust to hanger). Naturally, had to start the car with the new cans and what a difference! It's positively civilised.
Maybe a happy post Sat pm
Since the last post, we've had a weekend away in the caravan which was good fun, but prevented me from finishing the car; which was just tough.
I've been doing bits and pieces to the car since the MOT failure and have done all the required jobs except the steering restriction - which shouldn't take long - hope to do that on Friday eve - maybe get a retest on Saturday.
Did the new exhausts over the last couple of evenings and (nearly) finished attaching them tonight (only a bit of steel to connect rear of exhaust to hanger). Naturally, had to start the car with the new cans and what a difference! It's positively civilised.
Maybe a happy post Sat pm
Wednesday, 28 July 2010
Fail....
....but not so bad (though it will be expensive; hope that's not too contradictory!).
In case you didn't see previous post, I finally got the car in for an MOT today, and it failed.
The deffo fail was headlight adjustment, and I was spot on with that. Already playing around with adjustment.
Another point was the o/s top balljoint having too much play - turned out to be the nut inside the upright adaptor not being tight enough. So that's already fixed, though I had to take the suspension apart.
One more small point was the drivers seat belt bolt was 90% undone, so that's fixed too.
Big thing is the noise, and it's this that's going to cost as I decided that I may as well get some proper silencers and fit them. Several reasons, but primary at the mo is the get through MOT, but will also keep me in with the neighbours, who haven't complained but could. So it'll make the car much more useable (I'll be able to go out early and come back late).
Only downside is price, but I'm hoping to haggle! Will have to do a bit of work on exhausts to make fit but hey ho
I have 10 days to get car back in for partial retest, so need to get cracka lacking!
Will post agan when all jobs done, though you may have to wait till after test:)
In case you didn't see previous post, I finally got the car in for an MOT today, and it failed.
The deffo fail was headlight adjustment, and I was spot on with that. Already playing around with adjustment.
Another point was the o/s top balljoint having too much play - turned out to be the nut inside the upright adaptor not being tight enough. So that's already fixed, though I had to take the suspension apart.
One more small point was the drivers seat belt bolt was 90% undone, so that's fixed too.
Big thing is the noise, and it's this that's going to cost as I decided that I may as well get some proper silencers and fit them. Several reasons, but primary at the mo is the get through MOT, but will also keep me in with the neighbours, who haven't complained but could. So it'll make the car much more useable (I'll be able to go out early and come back late).
Only downside is price, but I'm hoping to haggle! Will have to do a bit of work on exhausts to make fit but hey ho
I have 10 days to get car back in for partial retest, so need to get cracka lacking!
Will post agan when all jobs done, though you may have to wait till after test:)
Tuesday, 27 July 2010
Tomorrow, Definately
Rang garage today only to be told no slots left so booked appointment for tomorrow!
Till then!
Till then!
Monday, 26 July 2010
MOT today...
...if they can fit me in!
I've done all I can think that needed doing, now just have to keep fingers crossed. If all goes well - ie it passes, straight to the PO to get RFL, then drive to work.
:D
I've done all I can think that needed doing, now just have to keep fingers crossed. If all goes well - ie it passes, straight to the PO to get RFL, then drive to work.
:D
Sunday, 25 July 2010
Nearly...
No pics unfortunately.
I was hoping to get car in for an MOT yesterday but hadn't got up early enough to get on with the few jobs I needed to.
However, I did have an excellent weekend working on the car and have just a couple of 5 min jobs to do, which I may do in a minute.
Everything painted in primer, car all cleaned, hoping for a MOT/rfl tomorrrow:D
Wish me luck!
I was hoping to get car in for an MOT yesterday but hadn't got up early enough to get on with the few jobs I needed to.
However, I did have an excellent weekend working on the car and have just a couple of 5 min jobs to do, which I may do in a minute.
Everything painted in primer, car all cleaned, hoping for a MOT/rfl tomorrrow:D
Wish me luck!
Subscribe to:
Posts (Atom)
